Watch the install,
start to finish.

The video is on the way. Until it lands, here is the whole install, the same three steps that came on your card.

Installs in three steps. Holds for the long haul.

Mounts to the back of the rim with nano tape. Grips hard, leaves no marks, and fits any standard porcelain bowl.

01

STEP 01

30 seconds drying time

Prime and align.

Fan on. Adhesion promoter on the clean, dry porcelain where the connectors sit. Then the alignment stickers at 11 and 1 o'clock. The bottom edge of each sticker is your height line.

// step 01 · adhesion promoter

02

STEP 02

Centered, no gap

Peel and position.

Peel both liners off the connectors, pulling down and away. Come up from below until the connector tops meet the bottom of the stickers.

// step 02 · peel + position

GET THIS RIGHT

Before you press

Set the height.

Connector top meets sticker bottom. That is what sets the height, and it is the one part of the install worth slowing down for. Mount it too high and you will feel it when you sit down.

// the most important part

03

STEP 03

20 seconds · then 24 hours dry

Press and hold.

Press both connectors firm and even for 20 seconds. Use it right away, but keep the connectors dry for 24 hours while the tape reaches full strength. No splashes, no cleaning, no wiping.

// step 03 · press + hold

AND THAT'S IT

The last thing

Done.

Peel the stickers off the rim and throw them away. Set the guest guide on the tank so everyone else knows where to aim. That is it.

// last bit · peel + place